HP D5970A - NetServer - LCII Installation Manual page 16

Chapter 1
4) Run Configuration
Assistant
(continued)
5) Choose a NOS
6) Select the NOS
Installation Mode
8
Setting Up the HP NetServer LPr
After you select Configuration and Installation
Assistant, you will have the option of using the
Hardware Verification and Labeling utility. This
utility allows you to check the connection of the LPr
to peripheral subsystems such as rack storage units.
Custom configuration mode and Replication
configuration mode are also available. Refer to
Chapter 11 for details.
Select the NOS you will install and the version, if
necessary. Installing the optional IntranetWare
NOS, which is part of the HP NetServer Software
Option Package, requires a decryption key. To get a
decryption key, you must send in the key request
form in the HP NetServer Software Option Package.
If you select certain versions of Novell
NetWare/IntranetWare or Microsoft Windows
NT Server, you will be asked, "Would you like
to use HP's automated mode of NOS
installation?"
If you want to use automated NOS installation,
select Yes. Choose automated NOS installation
mode for a first-time installation of Novell
NetWare/IntranetWare or Microsoft Windows
NT Server on a factory configured HP
NetServer LPr.
Perform a manual NOS installation if you
are installing a NOS other than Novell
Netware/IntranetWare or Microsoft
Windows NT Server, or if you replace HP
components. (For example, if you replace an
HP network interface controller board with a
third party board, install the NOS
manually.)