Configuring The System - HP D5970A - NetServer - LCII Installation Manual

Chapter 1

Configuring the System

1) Connect
Peripherals
2) Boot the HP
Navigator CD-ROM
3) Read the Readme
First File
4) Run Configuration
Assistant
Setting Up the HP NetServer LPr
For detail on rear panel interface connectors, see
Chapter 2.
For details on connecting the keyboard, mouse,
monitor, and UPS, see Chapter 10.
Turn on the monitor. Press the power-on button on
the HP NetServer, and press the eject button on the
CD-ROM drive.
Using the low profile CD-ROM drive is
NOTE:
slightly different than full-height units. The disk
drawer will spring out only part way when you push
the eject button. You must manually pull the drawer
open and manually close it after inserting a CD-
ROM.
Place the HP NetServer Navigator CD-ROM in the
drive, and close the drive. Press the Reset button. If
the system fails to restart, follow the instructions on
the screen.
When the HP Navigator starts, you can set the time
and date, and change the display language.
Select Readme First File from the HP Navigator
main menu. The Readme file contains the latest
information to help you install your HP NetServer.
If you want to change the language, select Set
Preferences from the HP Navigator main menu and
choose a language. Select Configuration and
Installation Assistant. Select Express from the next
screen to begin the Express mode of configuration.
7