Chapter 6
DIMMs
Removing DIMMs
You may need to remove a DIMM module to increase your memory configuration or to replace a defective
DIMM.
1. If the NetServer is operating, power down the NetServer.
2. Disconnect the power cord and any external cables connected to the NetServer. If necessary,
label each one to expedite re-assembly.
3. Remove the cover and turn in the NetServer feet (so that the NetServer will lie flat on its side).
WARNING
4. Lay the NetServer on its side (components showing).
5. Unsnap the air duct and move it out of the way.
6. Open the retaining latches.
7. Lift the DIMM completely away from the slot.
8. Place the DIMM in its anti-static container.
9. Repeat steps 6-8 for as many DIMMs as you need to remove.
The power supply will continue to provide standby current to the HP NetServer until
the power cord is disconnected.
Replacing Parts
87