Battery Problems; Installing A Replacement Battery - HP D5970A - NetServer - LCII Installation Manual
Hp netserver lpr installation guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and user manual (174 pages)
Table of Contents
Advertisement
Chapter 13
Battery Problems
If your HP NetServer LPr repeatedly loses its configuration or the CPU clock
stops, you should replace the battery or install an auxiliary battery.
WARNING
There is a danger of explosion if the battery is incorrectly
installed. For your safety, never attempt to recharge,
disassemble, or burn the old battery. Replace only with the
same or equivalent type recommended by the manufacturer.
Dispose of used batteries safely.
Installing a Replacement Battery
1. Turn off power to the HP NetServer LPr and unplug it.
2. Remove the front bezel and top cover (see Chapter 3).
3. Carefully, remove the old battery. Do not bend the clip that holds it in
place.
CAUTION
Dispose of the lithium battery properly. Disposal is regulated
in many
Battery
Figure 13-2. Battery on System Board
jusrisdictions.
Troubleshooting
107
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the D5970A - NetServer - LCII and is the answer not in the manual?