HP D5970A - NetServer - LCII Installation Manual page 40

Chapter 5
WARNING
The power supply will continue to provide standby current to
the NetServer LPr until the power cable is disconnected.
4. Remove the NetServer from the rack. See the last section in Chapter 9,
"Removing the NetServer from the Rack."
5. Remove the top cover from the NetServer (see Chapter 3, "Opening and
Closing the HP NetServer LPr").
CAUTION
Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
that the metal of the wrist strap contacts your skin.
6. Locate the DIMM sockets (see Figure 5-1).
CAUTION Use only HP DIMMs.
7. Install the DIMMs (see Figures 5-2 and 5-3):
a. Remove a DIMM from its container, handling the module by its edges.
Lay it on an anti-static surface.
b. Choose a socket into which you want to install a DIMM. DIMMs may
be installed in any combination, in any socket.
32
Figure 5-1. DIMM Locations
Installing Additional Memory