Hardware Problems; The Display Does Not Work - HP D5970A - NetServer - LCII Installation Manual

Chapter 13
2. Refer to Figure 13-1 and the Technical Reference Card inside the top
cover. Move the configuration memory switch, switch 5 on the system
board, to the "ON = CLEAR CONFIG" position.
3. Plug in the power cord, and turn on power to the HP NetServer. The
following message is displayed:
The configuration has been cleared. Set the
Clear Config switch to the OFF position before
rebooting.
4. Turn off power to the HP NetServer and unplug the power cord.
5. Return switch 5 on the system board to the OFF position.
6. Replace the top cover, and the front bezel, then plug in the power cord.
7. Turn on power to the HP NetServer LPr. The error message may be
displayed:
0012-34 : Incorrect System Configuration
8. Press the [F2] key to run the Setup utility.
9. Make any configuration changes that are required.
10. Press the [F10] function key and answer Yes to save the configuration,
then exit the Setup utility.

Hardware Problems

This section describes what to do if you have problems with your display, mass
storage devices, printer, accessory boards, keyboard, or mouse.

The Display Does Not Work

NOTE If the HP NetServer LPr has a large amount of memory
installed, it may take one minute for the first screen to display.
If the computer starts, and the keyboard, flexible disk drive, other disk
drives, and other peripheral devices seem to operate properly, do the
following:
Check that the monitor is plugged in and power is turned on.
Check that the brightness and contrast controls of the display are
properly set.
Troubleshooting
103