HP D5970A - NetServer - LCII Installation Manual page 64

Chapter 8
2. Align the VRM card on the secondary VRM slot. Note that the component
side should face towards the center of the enclosure like the VRM already
installed.
CAUTION Do not touch the components as you push the VRM card
down into the socket.
3. Gently push the VRM down into the socket until it is seated completely.
Make sure the VRM connector latch (see Figure 8-5) is raised to lock
position.
4. Align the additional processor module over the secondary processor
module slot so that the heat sink faces towards the center of the enclosure
like the processor module already installed.
5. Gently push down on the additional processor module until it is fully
seated.
Figure 8-4. Installing the Processor Module and VRM on the System Board
56
Installing Additional Processors