The Cd-Rom Drive Does Not Work; The Hard Disk Drive Does Not Work - HP D5970A - NetServer - LCII Installation Manual
Hp netserver lpr installation guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and user manual (174 pages)
Table of Contents
Advertisement
Chapter 13
The CD-ROM Drive Does Not Work
Check that a CD-ROM is inserted in the drive.
Check that the power and data cables are correctly connected to
the device.
If you intend to boot from the CD-ROM, make sure that Start from
CD-ROM is enabled in the Hardware Security submenu located under the
Security menu in the Setup utility.
For further information, see your CD-ROM documentation.
The Hard Disk Drive Does Not Work
If error messages displayed on the monitor indicate a hard disk failure, perform
these checks:
1. Check that all SCSI devices have unique SCSI IDs.
3. If you intend to boot from the hard disk drive, make sure that Start from
Hard Disk is enabled in the Hardware Security submenu located under
the Security menu in the Setup utility. Also verify that the SCSI ID of the
hard disk drive is correct for booting.
4. Refer to the HP NetServer Hard Disk Drive Troubleshooting Guide on the
HP Web Site at http://www.hp.com/netserver/servsup/trouble/ .
Troubleshooting
105
Advertisement
Table of Contents
Troubleshooting
