Reinstalling And Replacing The Speaker; Optical Drive; Removing An Optical Drive - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

Reinstalling and replacing the speaker

To reinstall or replace the power button assembly, reverse the previous removal steps.

Optical drive

This section describes how to remove and install an optical disk drive in a minitower workstation
configuration.

Removing an optical drive

1. Disconnect power from the system (see
2. Remove the side access panel (see
CAUTION:
(ESD) precautions while performing the system parts removal and replacement procedures:
— Work on a static-free mat.
— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your
body to the ground.
— Create a common ground for the equipment you are working on by connecting the static-free
mat, static strap, and peripheral units to that piece of equipment.
3. Remove the front bezel (see
4. Disconnect the power (1) and data (2) cables from the optical drive, as shown:
Figure 4-17
ENWW
To prevent damage to the workstation, observe the following Electrostatic Discharge
Removing the front bezel on page
Disconnecting the optical drive cables
Predisassembly procedures on page
Side access panel on page
Removing and replacing components
52).
58).
61).
67