Processor Heatsink; Removing The Processor Heatsink - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

8. Connect the data cable to the hard drive and to the system board, as shown in the following figure.
Figure 4-56
9. Connect the power cable (not shown).
10. Reinstall the workstation side access panel.

Processor heatsink

This section describes how to remove and install a processor heatsink.
Not all heatsinks are the same. The heatsink shown in the following figures is an example of what might
be installed in your workstation.

Removing the processor heatsink

To remove a heatsink:
1. Power down the workstation (see
2. Disconnect power from the workstation (see
3. Remove the side access panel (see
96 Chapter 4 Removal and replacement procedures
Connecting the data cable
Predisassembly procedures on page
Predisassembly procedures on page
Side access panel on page
52).
52).
58).
ENWW