HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 80

4. Disconnect the power (1) and data (2) cables from the back of the diskette drive, as shown:
Figure 4-20
5. As shown in the following figure, lift the green drive-lock release tab (1) and gently slide the drive
out of the chassis at the same time (2).
Figure 4-21
6. If not reinstalling or replacing the diskette drive, install an EMI filler in the diskette drive bay and
add a diskette drive bay blank to the front bezel.
To install a diskette drive, reverse the previous steps. You might need to remove the front bezel to install
the drive.
70 Chapter 4 Removal and replacement procedures
Disconnecting the diskette drive cables
Removing the diskette drive from chassis
ENWW