Replacing The Front Bezel; Bezel Blanks; Removing Bezel Blanks - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

2. Lift the two release snaps located on the front bezel (1), as shown in the following figure:
Figure 4-10
3. Rotate the front bezel away from the chassis to remove the bezel (2).

Replacing the front bezel

To replace the front bezel, engage the three small hooks protruding on one side of the front bezel with
matting holes on the workstation chassis and rotate the front bezel against the chassis front until the
bezel snaps into place.

Bezel blanks

This section describes how to remove bezel blanks

Removing bezel blanks

To remove bezel blanks:
1. Disconnect power from the system (see
2. Remove the front bezel (see
62 Chapter 4 Removal and replacement procedures
Removing the front bezel
Removing the front bezel on page
Predisassembly procedures on page 52).
61).
ENWW