To install a SAS hard drive:
1.
Disconnect power from the system (see
2.
Remove the side access panel (see
3.
Attach a SAS-to-SATA cable adapter to the connector on the SAS hard drive, as shown:
Figure 4-44
4.
Install the hard drive body into the hard drive mounting rails, as shown:
Figure 4-45
ENWW
Attaching the SAS-SATA adapter to the SAS hard drive
Installing the hard drive body into hard drive mounting rails
Predisassembly procedures on page
Side access panel on page
Removing and replacing components
52).
58).
89