HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 74

4. Unlatch the plastic snap that secures the cables inside the chassis (1), and then disconnect the
front panel I/O device assembly cables from the system board (2), as shown:
Figure 4-12
5. Remove the two smaller Torx screws (1) that hold the front panel I/O device assembly and bracket
to the chassis, as shown in the figure below.
6. Although not required, you can remove the mounting bracket from the I/O device assembly by
removing the two larger Torx screws (2) and pulling the mounting bracket away separately (4), as
shown in the following figure.
Figure 4-13
7. Pull the front panel I/O device assembly and bracket out about two inches away from the chassis
(3).
8. Guide the front panel cables through the chassis and out through the opening in the front of the
workstation chassis.
64 Chapter 4 Removal and replacement procedures
Removing front panel I/O device cables
Removing the front panel I/O device assembly
ENWW