Memory - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

3. Disconnect the memory fan cable from its connector on the system board (1), as shown:
Figure 4-26
4. Grasp the two green touch point tabs (1) and lift up and away from the system fan housing (2).
To replace the memory fan:
1. Align the two center and two outer hooks to the circular opening of the system fan housing, as
shown:
Figure 4-27
2. Press down on the memory fan housing until it drops into position.
3. Connect the memory fan cable to its connector on the system board.
Both the Memory fan connector and the Chip Set heatsink fan connector are white. To locate the
memory fan system board header connector, refer to the service label located on the inside of the
access panel.

Memory

This section describes how to remove and install memory modules.
ENWW
Removing the memory fan
Replacing the memory fan
Removing and replacing components 75