Diskette Drive (Optional); Removing A Diskette Drive - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

6. Insert the drive into the respective optical drive bay until it locks into place, as shown:
Figure 4-19
CAUTION:
to see if it can become easily disengaged. Failure to properly secure the drive can damage the
drive when moving the workstation.
7. Reinstall the front bezel.
8. Connect the power and data cables to the drive and system board.
NOTE:
in the workstation. The HP xw6600 Workstation is set to the RAID+AHCI MODE in BIOS at the
time of shipment.
The following constraints apply when the Configuration Mode for the workstation is set to:
IDE Mode—Only SATA ports 0 and 2 are functional for any SATA devices. RAID drives are not
accessible in this mode.
AHCI Mode—All SATA ports are functional for any SATA devices. RAID drives are not accessible
in this mode.
RAID + AHCI Mode—System BIOS cannot be updated from the optical drive. Also note that in this
mode the option ROM might not allow certain DOS drive letter access at this time.
9. Reinstall the side access panel.

Diskette drive (optional)

This section describes how to remove and install a diskette drive.

Removing a diskette drive

1. Disconnect power from the system (see
2. Remove the side access panel (see
3. Remove the front bezel (see
ENWW
Installing the optical drive
Verify that the optical drive is secure in the workstation chassis by pulling on the drive
Modes can be selected in the workstation BIOS that affect both optical and hard drives
Removing the front bezel on page
Predisassembly procedures on page
Side access panel on page
Removing and replacing components
52).
58).
61).
69