Power supply
This section describes how to remove the power supply.
Removing the power supply
To remove the power supply:
1.
Disconnect power from the system (see
2.
Remove the side access panel (see
3.
To ease installation of the power supply, write down the numbers on the cables so you can easily
reconnect them to the correct devices.
4.
Remove the memory fan and chassis fan assemblies.
5.
Disconnect cables from the system board, drives, and cards.
6.
Remove the four screws from the back panel (1), as shown:
Figure 4-23
7.
Slide the power supply toward the front of the chassis and lift it out of the chassis (2).
Reinstalling or replacing the power supply
To install the power supply, reverse the steps completed for removal.
CAUTION:
proper connection of power supply cables.
72
Chapter 4 Removal and replacement procedures
Removing the power supply
To prevent possible equipment damage, see
Predisassembly procedures on page
Side access panel on page
Power connections on page 73
52).
58).
to ensure
ENWW