Battery; Removing The Battery - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

8. As shown in the figure below, slide the system board forward to disengage the metal mounting
standoffs from the chassis (1).
CAUTION:
secured and are not removable.
Figure 4-61
9. Lift the system board out of the chassis (2), being careful not to damage the cables and rear panel
connectors.

Battery

This section describes how to remove and install the battery.
The battery that comes with the workstation provides power to the real-time clock and has a minimum
lifetime of about three years.
WARNING!
battery is handled improperly. Do not disassemble, crush, puncture, short external contacts, dispose in
water or fire, or expose it to temperatures higher than 60°C (140°F).
CAUTION:
battery is removed. To back up the CMOS settings, select the Save to Diskette option in the Computer
Setup (F10) Utility.
NOTE: Do not dispose of batteries, battery packs, and accumulators in household waste.

Removing the battery

To remove the battery:
1. Disconnect power from the system (see
2. Remove the side access panel (see
ENWW
Do not attempt to remove the system board mounting screws. These are permanently
Removing the system board
This workstation includes a lithium battery. There is a risk of fire and chemical burn if the
Before removing the battery, back up the CMOS settings in case they are lost when the
Predisassembly procedures on page
Side access panel on page
Removing and replacing components 101
52).
58).