HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 105

5. As shown in the following figure, place the SATA hard drive in the drive bracket, and align the four
threaded screw holes in the hard drive body with the four matching screw holes in the inner bracket
flanges.
Figure 4-54
6. Install four silver ANSI 6–32 screws through the oversized holes in the bracket outer flanges, and
into the bracket inner flanges and hard drive body, as shown in the figure above.
The hard drive body should be securely mounted within the mounting bracket.
7. As shown in the following figure, lift the locking lever on the left as you start to insert the drive and
bracket into the respective optical drive bay until it locks into place, and then check for secure fit.
Figure 4-55
ENWW
Installing the hard drive in bracket
Installing the hard drive in an optical drive bay
Removing and replacing components 95