Ieee-1394 (Optional) - HP xw4400 Service And Technical Reference Manual

To install a PCI card:
1. Disconnect power from the system
access panel
on page
2. Lift the PCI levers 1 by first pressing down and then up.
3. Remove the PCI slot cover 2.
4. Lower the PCI 3 card into the chassis. Verify that the keyed components of the card align with the
socket.
5. Close the PCI retention clamp 4 by rotating the clamp downward and pushing on the two green
snaps down from the rear panel of the chassis.
Figure 4-26

IEEE-1394 (optional)

To remove an IEEE-1394 card:
1. Disconnect power from the system
access panel
on page
2. Lift the PCI levers 1 by first pressing down and then up.
3. Disconnect the front I/O cable and power cable 2 from the card.
4. Lift the IEEE card 3 out of the chassis. Store the card in an anti-static bag.
ENWW
(Side access panel on page
77), if installed.
Installing the PCI card
(Side access panel on page
67).
(Predisassembly procedures on page
66), and remove the PCI retainer
(Predisassembly procedures on page
66), and remove the front bezel
Steps for removal and replacement of components
60), remove the side
(PCI retainer
60), remove the side
(Front Bezel
81