Power Button Assembly And System Speaker - HP Xw6400 - Workstation - 4 GB RAM Reference Manual

5. Separate the bracket 4 from the front panel I/O device assembly.
Figure 4-11
6. Slide the front panel cables through the chassis and out the front of the unit.
To replace the front panel I/O device assembly, reverse the previous steps.

Power button assembly and system speaker

The power button and the system speaker are part of the same assembly.
To remove the power button:
1. Disconnect power from the system
access panel
and the front panel I/O device assembly
2. Disconnect the power button assembly cable from the system board.
3. Disconnect the speaker wire and the hood sensor from the in-line connectors on the power button
assembly cable.
4. Remove the screw that secures the power button assembly to the chassis.
5. Dislodge the metal clip from the chassis by rocking the power button back and forth. Then slide
the power button assembly 2 out from the front of the chassis.
68 Chapter 4 Removal and replacement procedures
Removing the front panel I/O device assembly
(Predisassembly procedures on page
(Side access panel on page 63). Remove the front bezel
(Front panel I/O device assembly on page
57) and remove the side
(Front Bezel on page 64)
67).
ENWW