Power button assembly
This section describes how to remove and install the power button assembly.
Removing the power button assembly
To remove the power button assembly:
1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4.
Remove the front bezel (see
5.
Disconnect the power button cable from the system board as shown next.
Figure 5-11
6.
From inside of the chassis, push the tabs
78
Chapter 5 Replacing components
Predisassembly procedures on page
Removing the front bezel on page
Disconnecting the power button cable
Predisassembly procedures on page
Removing the side access panel on page
in from the chassis sides.
69).
69).
72).
75).
ENWW