Download  Print this page

Installing An Optical Drive (desktop Configuration) - HP Z400 Maintenance And Service Manual

Hide thumbs

Advertisement

Installing an optical drive (desktop configuration)

1.
Power down the workstation (see
2.
Disconnect power from the system
3.
Remove the side access panel
4.
If your system has an airflow guide, remove it (see
5.
Remove the front bezel (see
6.
Remove the bezel blank from the bay in which you want to install the drive.
7.
Install the four black metric M3 guide screws into the drive (1).
Figure 5-22
8.
Align the screws with the grooves in the drive bay and gently slide the drive into the bay until it
snaps into place (2).
CAUTION:
drive to see if it can be disengaged. Failure to properly secure the drive can cause damage to the
drive when moving the workstation.
ENWW
Predisassembly procedures on page
(Predisassembly procedures on page
(Removing the side access panel on page
Removing the front bezel on page
Installing the optical drive
Ensure that the optical drive is secure in the workstation chassis by pulling on the
75).
75),
78),
Removing the airflow guide on page
83),
Removing and installing components
110).
95

Advertisement

Table of Contents

   Related Manuals for HP Z400

Comments to this Manuals

Symbols: 0
Latest comments: