Installing An Optical Drive (Desktop Configuration) - HP FM064UT#ABA Maintenance And Service Manual

Installing an optical drive (desktop configuration)

1. Power down the workstation (see
2. Disconnect power from the system
3. Remove the side access panel
4. If your system has an airflow guide, remove it (see
5. Remove the front bezel (see
6. Remove the bezel blank from the bay in which you want to install the drive.
7.
Install the four black metric M3 guide screws into the drive (1).
Figure 5-22
8. Align the screws with the grooves in the drive bay and gently slide the drive into the bay until it
snaps into place (2).
CAUTION:
drive to see if it can be disengaged. Failure to properly secure the drive can cause damage to the
drive when moving the workstation.
94 Chapter 5 Replacing components
Predisassembly procedures on page
(Predisassembly procedures on page
(Removing the side access panel on page
Removing the front bezel on page
Installing the optical drive
Ensure that the optical drive is secure in the workstation chassis by pulling on the
74).
74),
77),
Removing the airflow guide on page
82),
109).
ENWW