Enhancements To Display Of Udp Connections Over Ipv4; Waiting For A Response To An Arp Request - Allied Telesis AT-8600 Release Note

68 Internet Protocol (IP) Enhancements
You can display IP filters with their filter number and filter type using the
command:
show ip filter[=0..999]
Command Changes
The following table summarises the modified commands:
Command
add ip filter
set ip filter
show ip filter
Enhancements to Display of UDP Connections over
IPv4
In this Software Version, the display of information about UDP connections has
been improved for connections over IPv4, with the following changes to the
output for the command show ip udp:
■
A new Process field displays the process that is using each connection.
■
The Local address field now displays the IP address of the last interface
that was used to transport UDP packets from the device, for the given
process.
Command Changes
The following table summarises the modified command:
Command
show ip udp

Waiting for a Response to an ARP Request

When a router or switch receives a packet and does not have an ARP entry for
the destination address, it broadcasts an ARP Request message over the egress
IP interface. If the router or switch does not receive a reply within a particular
time, it notifies the sending device that the destination is unknown.
This enhancement lets you increase the length of time that the router or switch
waits for a response, which is useful for routers or switches that communicate
with devices that are slow to respond. To configure the waiting time, use the
following new command to specify the wait timeout period in seconds:
set ip arpwaittimeout=1..30
The default is 1 second.
The easiest way to test a changed wait timeout period is to ping an unavailable
device. The timeout determines the delay between pinging an IP address and
receiving the reply that the device is unreachable.
Change
Modified number range for filter parameter.
New type parameter.
Modified number range for filter parameter.
New Filter Type parameter and options in field.
Type parameter modified to Pattern Type in field.
Change
New Process field and different information in the existing
Local address field.
Release Note
Software Version 2.8.1
C613-10477-00 REV B