Displaying A Subset Of Policy Rules; Command Reference Updates - Allied Telesis AT-8600 Release Note

162 Firewall Enhancements
Syntax
Description
Example
Syntax
Description
Example

Displaying a Subset of Policy Rules

This Software Version allows you to display only a specific rule, or a subset of
rules, when displaying details about firewall policies. Use the new rule
parameter in the command:
show firewall policy[=policy-name] [counter]
[rule=rule-id[-rule-id]] [summary]
Command Changes
The following table summarises the new and modified commands:
Command
show firewall policy

Command Reference Updates

This section describes the changed portions of the modified command and
output screens. For modified commands and output, new parameters and
fields are shown in bold.
reset firewall sipalg counter
RESET FIREwall SIPAlg COUnter
This new command resets the counters for the SIP ALG, which are displayed
by using the show firewall sipalg counter command.
To reset the counters for the SIP ALG, use the command:
reset fire sipa cou
set firewall sipalg
SET FIREwall SIPAlg
CALLIdtranslation={ON|OFF|YES|NO|True|False}
This new command modifies how the SIP ALG operates on the router or
switch.
The callidtranslation parameter specifies whether the Call-ID field of a SIP
message sent from the private side of the router or switch's firewall is
translated. When on, yes, or true, the SIP ALG replaces the IP address part of
the Call-ID with a globally routable IP address. The router or switch only
translates the Call-ID when a device within its private network has initiated
the SIP session. When off, no, or false, the SIP ALG sends SIP packets with the
Call-ID field unchanged. Call-ID translation is enabled by default.
To disable SIP Call-ID translation, use the command:
set fire sipa calli=off
Change
New rule parameter.
Release Note
Software Version 2.8.1
C613-10477-00 REV B