Set Ssh Server - Allied Telesis AT-8600 Release Note

152 Secure Copy (SCP)
Syntax
Description
Syntax
Description

set ssh server

SET SSH SERver [HOSTKey=key-id] [SERVERKey=key-id]
[EXPirytime=0..168] [IDLEtimeout=0..4294967295]
[LOGintimeout=1..600] [MAXSessions=0..6]
[SCP={ENAbled|DISabled}]
This command modifies the configuration of the Secure Shell server. The new
scp parameter allows you to enable or disable Secure Copy service.
Parameter Description
SCP Whether the SSH server supports SCP connections.
Default: enabled
ENAbled
DISabled
show loader
SHow LOAder
This command displays defaults for the loader and the progress of the current
load.
Figure 45: Example output from the show loader command
Loader Information
-----------------------------------------------------------
Defaults:
Method ............. SCP
File ............... -
Destination File.... -
Server ............. 192.168.1.1
HTTP Proxy ......... -
Proxy Port ......... Default ( 80 )
Username ........... alice
Asyn ............... -
Destination ........ Flash
Delay (sec) ........ 0
Current Load:
Method.............. SCP
.
.
.
Table 35: Modified parameters in output of the show loader command
Parameter
Method
Server
Username
Allows SCP connections.
Does not allow SCP connections.
Meaning
Method used to load files, one of: HTTP, SCP, TFTP, WEB, WWW,
ZMODEM, or None.
IP address or host name of the server. Used when method is set
to SCP, TFTP or HTTP.
The username set for the load or upload. This will only display if
a username has been set.
Release Note
Software Version 2.8.1
C613-10477-00 REV B