Pppoe Access Concentrator; Command Reference Updates - Allied Telesis AT-8600 Release Note

Software Version 2.8.1
Syntax
Description
Software Version 2.8.1
C613-10477-00 REV B

PPPoE Access Concentrator

This release introduces the ability for the PPPoE Access Concentrator and a
PPPoE Client to be active simultaneously. You can now specify the interface to
which the PPPoE Access Concentrator should attach.
Command Changes
The following table summarises the modified commands:
Command
add ppp acservice
delete ppp acservice
set ppp acservice
show ppp pppoe

Command Reference Updates

This section describes the changed portions of modified commands and output
screens. The new parameters and options are shown in bold for modified
commands.
add ppp acservice
ADD PPP ACSERVICE=service-name TEMPLATE=ppp-template
[ACRADIUS={OFF|ON}] [MAXSESSIONS=1..512]
[ACINTerface={NONE|interface}]
where:
■
interface is an interface name formed by concatenating an interface type
and an interface instance (e.g. eth0). Valid interface types are ETH and
VLAN.
This command adds a new PPP over Ethernet Access Concentrator service to
the router or switch. PPPoE hosts are able to connect to the router or switch
using this service.
To allow a PPPoE host to be defined on the router or switch as well as on an
Access Concentrator service, the acinterface parameter must be used. The
acinterface parameter specifies the interface to be used by the Access
Concentrator service. If none is specified, the Access Concentrator service uses
all valid interfaces. A service can be offered on several interfaces, but it is
necessary to issue one add ppp acservice command for each interface. For
example:
add ppp acservice=bob template=1 acint=eth0
add ppp acservice=bob template=1 acint=vlan5
To offer the service on all the Ethernet interfaces only, there is no need to use
the acinterface parameter, as it defaults to none.
The acinterface parameter supercedes the now deprecated vlan parameter in
this command.
Change
New acinterface parameter to supercede the now
deprecated vlan parameter.
New acinterface parameter to supercede the now
deprecated vlan parameter.
New acinterface parameter to supercede the now
deprecated vlan parameter.
New description for the interface parameter.
47