Configuring Users - Allied Telesis AT-8600 Release Note

Software Version 2.8.1
Monitoring sessions
Removing sessions
Software Version 2.8.1
C613-10477-00 REV B

Configuring Users

To copy files using SCP, you must be configured as a SSH user. Use the
command:
add ssh user=username {password=password|keyid=id}
[ipaddress=ipadd] [mask=mask]
Further details on configuring and managing SSH users can be found in the
Secure Shell chapter of the Software Reference.
SSH users must use either password authentication, or RSA public/private key
authentication. Further details on creating RSA keys can be found in the
Compression and Encryption Services chapter of the Software Reference.
Managing Secure Copy Sessions
You can monitor the current status of SCP sessions using the show ssh session
command. This shows both uploads and downloads, and displays whether the
router or switch is acting as a client or server. Use the command:
show ssh session=scp
To see details about SCP file transfers, such as the number of successful or
failed file transfers, use the command:
show ssh counter=scp
SSH and SCP sessions can now be deleted without disabling the SSH server.
When a SSH session begins, it is assigned an ID number. This number is used
to delete the session. To do this:
1. Use the show ssh session command to see current sessions.
Figure 44: Example output from the show ssh session=ssh command
ID Type Dir
----------------------------------------------------------
0 Listen In 0.0.0.0
1 Listen In ::
2 Shell In 192.168.2.5
3 Shell Out 192.168.100.264
4 SCP In 172.17.1.1
5 SCP Out 172.17.1.1
2. Delete the unwanted sessions.
To delete only the SCP sessions in
delete ssh session=4,5
To delete all sessions, use the command:
delete ssh session=all
Peer Address User
manager
john
manager
root
Figure 44, use the command:
143
State
Initial
Initial
Open
Open
Authen
Request