Displaying Sip Alg Session Details; Firewall Policy Rules Expansion - Allied Telesis AT-8600 Release Note

Software Version 2.8.1
Software Version 2.8.1
C613-10477-00 REV B
Command Changes
The following table summarises the new and modified commands:
Command
set firewall sipalg

Displaying SIP ALG Session Details

This Software Version allows you to display configuration details for the SIP
ALG, and details about the SIP sessions that are using the SIP ALG on the
router or switch. Use the new command:
show firewall sipalg ip=ipadd[-ipadd]|
[callid=call-id]|[counter]|[summary]
To show counters for the SIP sessions using SIP ALG, use the command:
show firewall sipalg counter
To reset the counters that are displayed with the show firewall sipalg counter
command, use the command:
reset firewall sipalg counter
Command Changes
The following table summarises the new and modified commands:
Command
reset firewall sipalg counter
show firewall sipalg
show firewall sipalg counter

Firewall Policy Rules Expansion

This Software Version increases the total number of rules and application rules
(apprules) that a firewall policy can associate with an interface to 2099. In
previous Software Versions the maximum number was 699.
The rules and apprules are cumulative. That is, a policy cannot assign more
than 2099 rules and apprules combined to an interface.
Firewall policy rules and apprules are created with the commands add firewall
policy apprule and add firewall policy rule. The range of ID numbers you can
specify for a rule or apprule is unchanged from 1 to 4294967295.
Command Changes
This expansion does not affect any commands.
Change
New command.
Change
New command.
New command.
New command.
161