Mld Snooping Group Membership Display; Change Of Maximum Query Response Interval For Mld - Allied Telesis AT-8600 Release Note

Software Version 2.8.1
Software Version 2.8.1
C613-10477-00 REV B

MLD Snooping Group Membership Display

The command show mldsnooping no longer displays the port members of the
All Routers group in the list of ports for groups other than the All Routers
group. This change makes the output of this command more like output from
the command show igmpsnooping.
To illustrate the change, an example of the previous output is shown in
Figure 32 on page 116, and an example of the new output is in
page 116.
Command Changes
The following table summarises the modified command:
Command
show mldsnooping
Change of Maximum Query Response Interval for
MLD
This Software Version changes the valid range for the MLD query response
interval. The maximum interval is now 8387 seconds, in accordance with
RFC 2710.
To set the query response interval, use the command:
set ipv6 mld qrinterval=1..8387
Note that if the router or switch acts as an MLDv1 querier and qrinterval is set
to more than 65 seconds, then the Maximum Response Code in MLDv1 query
packets will be set to 65535 milliseconds, because this is the highest valid value
for that field.
Command Changes
The following table summarises the modified command:
Command
set ipv6 mld
Change
More consistent output
Change
Changed range for qrinterval parameter.
113
Figure 33 on