Show Switch - Allied Telesis AT-8600 Release Note

Software Version 2.8.1
Syntax
Description
Software Version 2.8.1
C613-10477-00 REV B
Table 4: New parameters in output of the show lacp command
Parameter
Address learn thrash The thrashaction value that is applied to any trunks created by
action LACP. This specifies the action the router or switch takes when the
address learn thrash limit is exceeded on the trunk.
Disable Learning
Disable Port
Link Down
Disable Vlan
Address learn thrash The thrashtimeout value to apply to any trunks created by LACP. It
timeout specifies the time, in seconds, for which a trunk remains disabled
after being disabled by thrashing protection.
If 'None' is shown, the trunk remains disabled until manually
re-enabled.

show switch

SHow SWItch
This command now shows information about the hardware route update
queue (Figure 5, Figure
Figure 5: New parameters in output of the show switch command when hardware
learning delay is disabled
Switch Configuration
-----------------------------------------------------------
Switch Address ............. 00-00-cd-12-78-03
Learning ................... ON
Ageing Timer ............... ON
IP route:
Learn delay ............. OFF
queue limit ....... 1000000
queue maximum ..... 1500000
queue default ..... 1000000
Updating hardware(status) 0 (Pending)
.
.
.
Description
Learning is disabled on all ports in the trunk
All ports in the trunk are disabled but the links
will remain up
All ports in the trunk are disabled and the links
will go down
All ports in the trunk are disabled for the
VLAN that thrashing occurring on.
6, Table 5).
41