Mstp Enhancement; Command Reference Updates - Allied Telesis AT-8600 Release Note

50

MSTP Enhancement

Syntax
Description
Example
Syntax
Description
Example
MSTP Enhancement
Two new commands have been added to simplify MSTP operation.
Command Changes
The following table summarises the new commands:
Command
disable mstp port
enable mstp port

Command Reference Updates

This section describes each new command.
disable mstp port
DISable MSTP POrt={port-list|ALL}
where:
■
port-list is a port number, range (specified as n-m), or comma-separated list
of port numbers and/or ranges. Port numbers start at 1 and end at m,
where m is the highest numbered Ethernet switch port, including uplink
ports.
This new command disables the Multiple Spanning Tree algorithm on the
specified ports, or all ports, for both the CIST and all currently configured
MSTIs. This command offers a shorter alternative to using the disable mstp
cist port command, followed by the disable mstp msti port command.
To disable the CIST and all MSTIs on ports 10-15, use the command:
dis mstp po=10-15
enable mstp port
ENAble MSTP POrt={port-list|ALL}
where:
■
port-list is a port number, range (specified as n-m), or comma-separated list
of port numbers and/or ranges. Port numbers start at 1 and end at m,
where m is the highest numbered Ethernet switch port, including uplink
ports.
This new command enables operation of the Multiple Spanning Tree algorithm
on the specified ports, or all ports, for the both the CIST and all currently
configured MSTIs. This command offers a shorter alternative to using the
enable mstp cist port, command, followed by the enable mstp msti port
commands.
To enable the CIST and all MSTIs on ports 10-15, use the command:
ena mstp po=10-15
Change
New command
New command
Release Note
Software Version 2.8.1
C613-10477-00 REV B