Enclosure Management Commands - HP BladeSystem bc2000 - Blade PC User Manual

(continued)
SET SNMP CONTACT
<contact>
SET SNMP LOCATION
<location>
SHOW NETWORK
SHOW SNMP

Enclosure Management Commands

Table 5-5
Command
CLEAR SYSLOG
ENCLOSURE
SET SYSLOG POLICY
[ENCLOSURE | BAY ]*
POWEROFF ENCLOSURE
{FORCE}
RESTART
ENWW
Configures the name of the system contact.
Configures the SNMP location of the enclosure.
The default location is blank.
Displays the DHCP state, Dynamic DNS state, IP address,
subnet mask, gateway address, primary and secondary DNS
addresses, HTTP and HTTPS server status, SNMP status,
Secure Shell status, and Telnet status of the enclosure.
Displays the SNMP system name, location, and contact, read
community name, write community name, and a list of the trap
destinations.
Description
Clears the enclosure system log.
This command turns system log message posting on or off per
severity type. The Integrated Administrator preservers this
setting across all logins/users
Performs a graceful shutdown of the enclosure. Each blade is
first gracefully shut down. If the FORCE argument is given, the
enclosure and all blades are immediately shutdown.
Restarts the Integrated Administrator. This does not affect
operation of bays in the system.
name is public. The default
write community name is
blank.
Only enclosure
administrators may execute
this command.
The <contact> must be 1-20
characters long and can
include alphanumeric, dash,
underscore, and space
characters. If spaces are part
of this information, enclose
the information in quotes.
Only enclosure
administrators may execute
this command.
The <location> must be 1-20
characters long and can
include alphanumeric, dash,
underscore, and space
characters. If spaces are part
of this information, enclose
the information in quotes.
None
Only enclosure
administrators may execute
this command.
Restrictions
Only enclosure administrators
may execute this command.
Once deleted, this information
cannot be restored.
None
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Operating the Command Line Interface 59