HP BladeSystem bc2000 - Blade PC User Manual page 71

(continued)
SHOW DATE
SHOW DISPLAY
SHOW ENCLOSURE FAN
[fan number> | ALL]<
SHOW ENCLOSURE INFO
SHOW ENCLOSURE
POWER SUPPLY
[<power supply number> |
ALL]
SHOW ENCLOSURE
STATUS
SHOW ENCLOSURE TEMP
SHOW RACK NAME
<rack name>
SHOW SYSLOG
ENCLOSURE
SHOW TRAY INFO
UPDATE IMAGE
<url>
ENWW
Displays the current date, time, and time zone of the internal
clock of the enclosure.
Displays whether event notification is on or off.
Displays the status, redundancy, and partner, speed, part
number for the requested fan.
If ALL is entered, this information is shown for all fans.
Displays the enclosure name, type, part number, serial
number, and asset tag; the Integrated Administrator software
(including build #) and hardware version; Integrated
Administrator MAC address, and the interconnect tray type,
part number, and serial number
Displays the power supply status, AC input status, capacity,
input voltage range #1 (measured in Volts), input voltage
range #2 (if necessary, measured in Volts), input frequency
range (measured in Hertz), part number, serial number, and
hardware revision for the specified power supply if one is
specified or for all power supplies if ALL is given.
Under an enclosure status heading, this command displays
the health, Integrated Administrator health, and unit
identification LED of the enclosure.
Under a power status heading, this command displays the
power status and capacity.
Displays the locale, status (OK, warm, degraded, or failed),
temperature in degrees Fahrenheit, and temperature sensors.
Shows the name for the rack where the enclosure resides
The default rack name is UnnamedRack.
Displays the syslog of the enclosure with 22 lines per screen.
Typing q quits the command, any other key shows the next
screen if more information exists to display.
Typing c continuously displays the System Log without page
breaks.
Displays the manufacturer, product name, part number, serial
number, and spare number of the interconnect tray.
Downloads a new image from a blade over the network and
uses the image to update the firmware of the enclosure.
None
None
None
None
None
None
None
None
Only enclosure administrators
may execute this command.
None
Only enclosure administrators
may execute this command.
URL can be any of the
following:
●
●
●
●
●
Operating the Command Line Interface
http://host/path
tftp://host/path
ftp://
username:password
@host/path
ftp://host/path where
host is a fully qualified
domain name or an IP
address and path is the
61