HP BladeSystem bc2000 - Blade PC User Manual page 75

Table 5-7 Command Line Event Messages (continued)
User Event Messages
User Permission Change
Enclosure Event Messages
Enclosure Shutdown
Enclosure Status Change
Fan Inserted
Fan Removed
Fan Status Change
Power Supply Inserted
Power Supply Overload
Power Supply Redundancy Change
Power Supply Removed
Power Supply Status Change
Restart Event
Thermal Status Change
Bay Event Messages
Bay Event
Blade Inserted
Blade Removed
Blade Status Change
ENWW
One of the following has occurred:
●
A user has been added, removed, or modified.
● A user's group membership has been modified.
The blade PC bay membership has been changed for a group
with at least one user.
The enclosure is being shut down
The Integrated Administrator detected a change in status due
to a change in the state of one or more hardware components
or blade PC readings.
A fan has been inserted.
A fan has been removed.
The status of fan has changed.
A power supply has been inserted.
The power system is overloaded. Check each power supply
status to determine cause.
The power supplies are now either redundant or no longer
redundant.
A power supply has been removed.
The status of a power supply has changed.
The Integrated Administrator is about to restart.
The state of a thermal sensor has changed.
NOTE: For BC2x00 blades, thermal events reported by the
bay sensor include the bay temperature for the hottest
subcomponent sensor reported value.
A blade PC bay has been assigned or unassigned from a
group.
A blade PC was inserted into the enclosure.
A blade was removed from the enclosure.
The health service or Blade Management Controller (BMC)
detected a change in status due to a change in the state of
one or more hardware components or due to a software OS
lockup if Automatic System Recovery (ASR) is enabled on the
blade.
Operating the Command Line Interface 65