HP BladeSystem bc2000 - Blade PC User Manual page 129

You can manually place the Integrated Administrator in Flash Recovery mode:
1. Connect a local client device to the Integrated Administrator (serial) console connector using the
nullmodem serial cable (provided with the enclosure). See
Devices on page
2. Press and hold the enclosure Unit Identification button (1) and press the Integrated Administrator
Reset button (2) simultaneously on the rear panel of the blade PC to place the enclosure in Lost
Password/Flash Disaster Recovery mode.
3. When the serial console prompt appears, press the
NOTE: This command is case-insensitive.
Pressing the
Flash Disaster Recovery mode and reboots the system.
This command boots the system in Flash Disaster Recovery mode, prints a message, and resets the
enclosure.
Upon entering Flash Disaster Recovery mode, the Integrated Administrator attempts to acquire a DHCP
address. If successful, the Integrated Administrator prompts the user for:
●
IP address of the TFTP server
●
Filename of the ROM on the TFTP server
ENWW
11.
L key launches Lost Password recovery mode. Pressing any other key exits Lost Password/
Requirements for Local Client
F key.
Launching Flash Disaster Recovery 119