Issuing Endurance Commands
You can issue the Endurance commands using either:
•
Endurance Manager – the command syntax for this method is documented in the
Command section of each command.
•
MTCCONS (the Endurance Manager Console) – the command syntax for this method is
documented in the Console Syntax section of each command. Refer to page
MTCCONS information, including a description of the MTCCONS parameters.
Using Endurance Manager or MTCCONS, you can issue commands from:
•
The CE operating system
•
An IOP that is active in the Endurance server configuration
•
A properly configured remote workstation that is running Endurance Manager
When using Endurance Manager, you can access the commands by the methods listed in
5-1.
Table 5-1 Accessing Endurance Manager Commands
To access...
All commands
Commands for a specific
Endurance server component
Commands
To execute command . . .
1. From the main dialog box menu, select Tools
Control. This displays the Display and Control dialog box.
2. Select the command and any parameters.
3. Click Apply.
1. In the main dialog box, double click on the Endurance
component for which you want to execute a command. This
displays only the commands that are available for that
component in a Display and Control dialog box.
2. Select the command and any parameters.
3. Click Apply.
7-16
for
Table
Display and
5-3