Managing Users; Modifying A User's Rights To Blade Pc Bays; Creating A New Group With The Updated Access Rights; Modifying Group Rights To Blade Pc Bays - HP BladeSystem bc2000 - Blade PC User Manual

This command displays the status of enclosure health, Integrated Administrator health, and the
Unit Identification LED under the heading "enclosure status," and displays the status and capacity
of the power supplies of the enclosure under the heading "power status."
SHOW ENCLOSURE TEMP
This command displays the location, status (OK, warm, degraded, or failed), and temperature
(degrees Fahrenheit or Celsius) for all the temperature sensors of the enclosure.

Managing Users

NOTE: Only enclosure administrators may perform these tasks.
Restricted default names of group and user accounts (Administrator, switch, switcha, switchb, and SAM)
are not case-sensitive. Nondefault group and user names are case-sensitive.

Modifying a User's Rights to Blade PC Bays

You can only modify a user's rights to blade PC bays by modifying their group rights, specifically by
choosing one of the following methods:
●
Creating a new group for the user with the updated access rights to the blade PC bays
●
Modifying the rights to blade PC bays for a group to which the user has membership

Creating a New Group with the Updated Access Rights

To create a new group with the updated blade PC access profile you wish to assign your user, see
Adding a Group on page

Modifying Group Rights to Blade PC Bays

To modify group rights to blade PC bays using the Web-based user interface:
1. Click the Administration tab.
ENWW
77.
Managing Users 105