Hyperterminal Window - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Figure 2–21: HyperTerminal window
9. At the C> prompt, type ipconfig and press Enter. The HyperTerminal
window displays with configuration information listed as follows:
— MAC Address
— IP Address (default is 10.1.1.10, factory preset is 10.1.1.10)
— Subnet Mask (default is 255.0.0.0).
— Gateway Address (default is 0.0.0.0)
— Auto Negotiate.
— Speed.
— Duplex.
Only the IP Address, Subnet Mask, and Gateway Address fields are
configurable.
10. Change the IP address, subnet mask, and gateway address as directed by the
customer's network administrator. To change switch network addresses, type the
following at the C> prompt and press Enter.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
edge switch 2/24 installation guide
Installing and Configuring the Edge Switch 2/24
2-33