Enable Or Disable Host Control; Management Page-Osms Tab - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Enable or Disable Host Control

Perform this procedure to toggle (enable or disable) host control of the switch through
the OSMS. The OSMS feature must be installed to access this control. Refer to
12: Configure Open Systems Management Server
instructions. If the feature is not installed, the message "Feature not
installed" displays. To enable or disable host control:
1. At the Configure window, click the OSMS tab. The Management page displays
with the OSMS tab selected, as shown in
Figure 2–12: Management page—OSMS tab
2. Perform one of the following steps as required:
a. Click Enable to activate the OSMS. The message "Your changes to
the host control enable state have been successfully
activated" displays.
b. Click Disable to deactivate the OSMS. The message "Your changes to
the host control enable state have been successfully
activated" displays.
edge switch 2/24 installation guide
Installing and Configuring the Edge Switch 2/24
(Optional)" on page 2–41 for
Figure 2–12.
"Task
2-21