Hyperterminal Window - HP StorageWorks Edge Switch 2/12 Installation Manual

8. At the > prompt, enter the user-level password (the default is password). The
Figure 9: HyperTerminal window
9. At the C> prompt, enter ipconfig. The HyperTerminal window displays
10. If necessary, change the IP address, subnet mask, and gateway address as
Edge Switch 2/12 Installation Guide
— Stop bits: 1
— Flow control: Hardware or None
When the parameters are set, click OK. The HyperTerminal window displays.
password is case sensitive. The HyperTerminal window displays.
(Figure 9). The configuration information is listed below:
— MAC Address
— IP Address (default (factory preset) is 10.1.1.10)
— Subnet Mask (default is 255.0.0.0).
— Gateway Address (default is 0.0.0.0)
Only the IP Address, Subnet Mask, and Gateway Address fields are
configurable.
directed by the network administrator. To change switch network addresses,
enter the following at the C> prompt:
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
Installing and Configuring the Edge Switch 2/12
43