Configure Switch Parameters; Configure Switch Parameters Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

c. Type a switch description of 255 alphanumeric characters or less in the
Description field.
d. Type the switch's physical location (255 alphanumeric characters or less) in
the Location field.
e. Type the name of a contact person (255 alphanumeric characters or less) in the
Contact field.
2. Click Activate to configure the switch identification and close the dialog box.

Configure Switch Parameters

Perform this procedure to configure the switch's preferred domain ID, insistent
domain ID, rerouting delay, and domain RSCNs. The switch must be set offline to
configure the preferred domain ID. To configure switch parameters:
1. Ensure the switch is set offline.
2. At the Hardware View, select Configure > Operating Parameters > Switch
Parameters. The Configure Switch Parameters dialog box displays, as shown
in Figure
Figure 2–33: Configure Switch Parameters dialog box
a. At the Preferred Domain ID field, type a value between 1 through 31. The
domain ID uniquely identifies each switch in a fabric.
If the switch is attached to a fabric element, the switch and element must have
unique domain IDs. If the values are not unique, the E_Port connection to the
element segments and the switch cannot communicate with the fabric.
edge switch 2/24 installation guide
2–33.
Installing and Configuring the Edge Switch 2/24
2-45