Task 5: Configure Network Information - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

3. Type the feature key and click Activate. The interface displays a confirmation
page with a warning, stating this action overrides the current set of switch
features.
4. Click Activate to activate the new feature key. The switch performs an IPL when
the feature key is activated.
NOTE: When Activate is selected, all current features are replaced with new features.

Task 5: Configure Network Information

The Edge Switch 2/24 is delivered with the following default network addresses:
• MAC address—the media access control (MAC) address is programmed into
FLASH memory on the CTP card at the time of manufacture. The MAC address is
unique for each switch, and should not be changed. The address is in
xx.xx.xx.xx.xx.xx format, where xx is a hexadecimal pair.
NOTE: References to the CTP in this manual are to the control processor logic contained
on the switch motherboard. If an event occurs that indicates the CTP as faulty, replacement
of the switch assembly is required.
• IP address—the factory preset default internet protocol (IP) address is 10.1.1.10.
The default IP address is also 10.1.1.10.
If Reset Configuration is selected from the product manager application, the
switch resets to the default address of 10.1.1.10.
If multiple switches are installed on the same LAN, each switch (and the HAFM
server) must have a unique IP address. One switch can use the factory-set address,
but the addresses of the remaining switches must be changed.
NOTE: If you have enabled additional port function with the HP Flexport Feature since the
switch shipped from the factory, resetting the configuration will return this feature to the factory
default of only 8 ports enabled. You must re-enable the additional ports using the Configure
Feature Key dialog box (see
WARNING: This operation resets all configuration including any optional
features that have been installed. You will need to re-enter your feature key to
enable all optional features after resetting the configuration parameters.
edge switch 2/24 installation guide
Installing and Configuring the Edge Switch 2/24
"Task 11: Configure Feature Key (Optional)" on page 2–39).
2-29