Hyperterminal Window; Disconnect Now Dialog Box - HP 316095-B21 Installation Manual

The password is case sensitive. The HyperTerminal window is displayed with a C> prompt at
the top of the window
Figure 13

HyperTerminal window

9. At the C> prompt, enter ipconfig and press Enter.
The HyperTerminal window is displayed with configuration information listed as follows:
• MAC Address
• IP Address (default is 10.1.1.10, factory preset is 10.1.1.10)
• Subnet Mask (default is 255.0.0.0).
• Gateway Address (default is 0.0.0.0)
Only the IP Address, Subnet Mask, and Gateway Address are configurable.
10.Change the IP address, subnet mask, and gateway address as directed by the network
administrator. To change Edge Switch network addresses, enter the following at the C> prompt:
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is always xxx.xxx.xxx.xxx, the subnet mask is always
yyy.yyy.yyy.yyy, and the gateway address is always zzz.zzz.zzz.zzz. The octets xxx,
yyy, and zzz are decimals from zero through 255. If a network address is to remain
unchanged, type the current address in the respective field.
When the new network addresses are configured at the Edge Switch, the message Request
completed OK is displayed at the bottom of the HyperTerminal window.
11.Select File > Exit to close the HyperTerminal application.
A message box is displayed
Figure 14

Disconnect Now dialog box

(Figure 13).
(Figure 14).
Edge Switch 2/24 installation guide 39