Configure Snmp Trap Message Recipients - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

g. Click the check box in the Port Binding column to enable or disable port
binding (default is disabled). A check mark in the box indicates port binding
is enabled and the port can connect only to a device with a WWN listed in the
Bound WWN column.
h. If port binding is enabled, type the WWN or nickname of the device attached
to the port in the Bound WWN column.
— If the check box in the Port Binding column is checked and a WWN or
— If the check box in the Port Binding column is checked but no WWN or
— If the check box in the Port Binding column is not checked, any device
2. Click Activate to save the configuration information and close the dialog box.

Configure SNMP Trap Message Recipients

Perform this procedure to configure community names, write authorizations, and
network addresses and for up to 6 SNMP trap message recipients. A trap recipient is a
management workstation that receives notification (through SNMP) if a switch event
occurs.
To configure SNMP trap recipients:
1. At the Hardware View for the selected switch, choose Configure > SNMP
Agent. The Configure SNMP Agent dialog box displays, as shown in
Figure 2–38.
edge switch 2/24 installation guide
nickname appears in the Bound WWN field, only the specified device
can attach to the port.
nickname appears in the Bound WWN field, no device can connect to the
port.
can connect to the port.Use the vertical scroll bar as necessary to display
additional port information rows (up to 24 ports).
Installing and Configuring the Edge Switch 2/24
2-55