Configure Fabric Parameters; Switch Page-Fabric Parameters Tab - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing and Configuring the Edge Switch 2/24

Configure Fabric Parameters

Perform this procedure to configure the fabric operating parameters, including
resource allocation time out value (R_A_TOV), E_D_TOV, switch priority, and
interop mode. The switch must be set offline. To configure parameters:
1. If required, set the switch offline as follows:
a. At the Configure panel, select the Operations option at the left side of the
panel. The Operations panel opens and the Switch page displays with the
Beacon tab selected
b. Click the Online State tab, then click Set Offline. The message "Your
operations changes have been successfully activated"
appears.
2. At the Operations panel, select the Configure option at the left side of the panel.
The Configure panel opens with the Ports page displayed.
3. At the Configure panel, click the Switch tab, then click the Fabric Parameters
tab. The Switch page displays with the Fabric Parameters tab selected, as shown
in Figure
Figure 2–7: Switch page—Fabric Parameters tab
2-14
2–7.
edge switch 2/24 installation guide