HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual page 43

a. At the Preferred Domain ID field, type a value between 1 through 31. The
domain ID uniquely identifies each switch in a fabric.
If the switch is attached to a fabric element, the switch and element must have
unique domain IDs. If the values are not unique, the E_Port connection to the
element segments and the switch cannot communicate with the fabric.
b. At the Insistent Domain ID field, select Enabled or Disabled. When this
parameter is enabled, the domain ID configured in the Preferred Domain ID
field becomes the active domain identification when the fabric initializes. This
parameter is enabled only if the optional SANtegrity feature is installed.
c. At the Rerouting Delay field, select Enabled or Disabled. When this
parameter is enabled, traffic is delayed through the fabric by the specified
error detect time out value (E_D_TOV). This delay ensures Fibre Channel
frames are delivered to their destination in order, even if a change to the fabric
topology creates a new (shorter) transmission path.
d. At the Domain RSCNs field, select Enabled or Disabled. When this
parameter is enabled, attached devices can register to receive notification
when another attached device changes state.
4. Click Activate to save and activate the changes. The message "Your changes
to the operating parameters configuration have been
successfully activated" appears.
5. If fabric parameters require configuration, go on to Configure Fabric Parameters.
If the configuration is complete, set the switch online as follows:
a. At the Configure panel, select the Operations option at the left side of the
panel. The Operations panel opens and the Switch page displays with the
Beacon tab selected
b. Click the Online State tab, then click Set Online. The message "Your
operations changes have been successfully activated"
displays.
edge switch 2/24 installation guide
Installing and Configuring the Edge Switch 2/24
2-13