Hyperterminal Window - HP storageworks 2/32 Installation Manual

Installing and Configuring the Edge Switch 2/32
8. At the > prompt, type the user-level password (the default is password) and
Figure 9: HyperTerminal window
9. At the C> prompt, type ipconfig and press Enter. The HyperTerminal
10. Change the IP address, subnet mask, and gateway address as directed by the
42
press Enter. The password is case sensitive. The HyperTerminal window
displays with a C> prompt at the top of the window
window displays with configuration information listed as follows:
— MAC Address
— IP Address (default is 10.1.1.10, factory preset is 10.1.1.10)
— Subnet Mask (default is 255.0.0.0).
— Gateway Address (default is 0.0.0.0)
Only the IP Address, Subnet Mask, and Gateway Address fields are
configurable.
customer's network administrator. To change switch network addresses, type
the following at the C> prompt:
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
Press Enter.
(Figure 9).
Edge Switch 2/32 Installation Guide