Installing and Configuring the Edge Switch 2/24
Zoning and Switch Binding
SANtegrity switch binding parameters have no effect on zoning configurations.
However, if a device WWN is in a specific zone, but the WWN is not in the
membership list, the device cannot log in to a switch port and cannot connect to other
devices in the zone with switch binding enabled.
Enable or Disable Switch Binding
Perform this procedure to configure (enable or disable) switch binding:
1. Ensure the SANtegrity feature key is installed and configured. For instructions,
refer to
"Task 11: Configure Feature Key
2. At the Hardware View, select Configure > Switch Binding > Change State. The
Switch Binding - Change State dialog box displays, as shown in
Figure 2–35: Switch Binding - Change State dialog box
3. Perform one of the following:
•
To enable switch binding, click the Enable Switch Binding check box to add
a check mark. Go to
•
To disable switch binding, click the Enable Switch Binding check box to
remove the check mark, then click Activate to enable the change and close the
dialog box.
4. Select a Connection Policy radio button as follows:
•
Restrict E_Ports - Select this button to restrict connections from specific
fabric elements to switch E_Ports. WWNs can be added to the membership
list to allow element connection and removed from the list to prohibit element
connection. Devices are allowed to connect to any F_Port or FL_Port without
restriction.
2-50
(Optional)" on page 2–39.
step 4
to set the connection policy.
Figure
edge switch 2/24 installation guide
2–35.